lost my 1st axle and possible rear end
 

only 2000 miles on the car broke the passenger side axle, the CV broke and deffiantly sumthing wrong with the rear end. dumped the clutch at about 3000 and it went snap.

anyone else havn problems????

nope but I guess I better stop dumping the clutch. i have done it a few times at around 4000+. So i guess i better stop. Thanks for the heads up

iv done mine around 3200 numerous times and i guess this time it decided to go bang!!!!

There's another forum post going on right now that is talking about the same thing. IMO this seems to be ocurring more and more and everytime I read about it, it's on the passenger side of the car. A buddy of mine at Camaro Fest snapped his on the passenger side as well and had to limp off the track. Luckily he was able to get a new pair there from Janetty and the Lingenfelter race crew installed them for him. Thing is, my buddy had no mods done except a cold air intake, no tune or anything. Here's the other thread. http://www.camaro5.com/forums/showthread.php?t=88829

The stock cvs are not up to the task,give us a call and will get you something that will get you back home no matter how you treat them :)

dont know if I'd fully agree with that.

Uncle Robin runs the stock rear axles with slicks on his 6XX rwhp LSA powered camaro. and he's cutting 1.60 60's






that being said, given the right circumstances, launching a 4000lbs car can take its toll on parts.

Upgrade the axles.. they will handle the abuse. The stock axles suck.

just curious, are you stock height or have you lowered car? seems to be more common on lowered cars

this cant be on stock tires?

Yep, the BMR shop car broke an axle. Cant remember which one but it inst a big power car either.
They installed a set of our axles a couple weeks ago so it doesnt happen again.
It's usually the axle that breaks right where it necks down at the boot.

Thanks
Chris @ Gforce

snapped my passenger rear axle a few weeks ago, 1200 miles bone stock 2ss m6, dealer fixed it, now i have droning on the hwy @ 60-70mph in 5th n 6th gears around 2000rpm.

axle
 

jay just posted my nightmare 2 axles and 1 drive shaft in 4000 miles on 2010 camaro 426 hp 6 spd man. never more than 4500 rpm factory installed launch.