Supercharged Cobra Blows Up On Dyno
 

Ouch! :yikes: Man, I hate to see this happen... but I watched it twice.

:yikes:DAMN that engine got blown to the 9th level of hell! I can't believe someone would eff up that bad on a dyno!

That sucks

that guy sitting on the back is lucky he didn't get burned! :confused0068:

Bet the guy in the drivers seat went in his pants.

It is tragedy, but I watch this like ten times

Sadly, I'll admit I did too. I just couldn't figure out if they threw a rod, or, was it compression failure?

:yikes:.......:sm0:

This has shown up on here before. People commented on the fat guy over the rearend and the shift light being on for a good while before the motor cooked. :yikes: Sucks for that owner.

http://img.photobucket.com/albums/v4...angs/Ouch4.jpg

http://img.photobucket.com/albums/v4...angs/Ouch5.jpg

http://img.photobucket.com/albums/v4...angs/Ouch6.jpg

http://img.photobucket.com/albums/v4...angs/Ouch3.jpg

http://img.photobucket.com/albums/v4...angs/Ouch2.jpg



He removed the limiter and spun the 5.4 to hard. He already had a MMR built/prepped shortblock waiting to go in. Supposed to be good to 2,000hp.

Those pics are a sad sight.:facepalm: Now I'm going to have nightmares!

Yea he said the 800rwhp club was pretty expensive. :)

Car had a 2.8 Kenne Bell. Said he was running 24 pounds of boost and at 6500rpm #4 rod let go.

i cant see the vid at work.


rpm is the enemy of GT500's. thats a gt500 engine not a cobra. those heads have rectangular intake ports. thats an 5.4 NVH iron block.


everyone knows the rpm limits of the stock short block. i wonder why folks keep trying to rev it past 6100. the iron block has 1250hp limits anyway. the cylinders move around at that level.

he wanted that to happen