Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
  
TireRack
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums
Reload this Page Search Results
Homepage Garage Wiki Register Community Calendar Today's Posts Search


Page 1 of 17 1 234511 Last »
Showing results 1 to 30 of 500
Search took 0.07 seconds. Search: Posts Made By: CamaroCracka
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 05-22-2024, 11:58 AM
Replies: 4
Views: 246
Posted By CamaroCracka
There was a thread on here about the Atturo tires...

There was a thread on here about the Atturo tires and the OP liked them, mostly for the price. He was running stockish power. They are around 500 treadwear and I believe W rated, so they seem to be a...
Forum: 5th Gen Camaro SS LS LT General Discussions 05-22-2024, 11:49 AM
Replies: 9
Views: 387
Posted By CamaroCracka
I had to do a couple trips to SC and took the...

I had to do a couple trips to SC and took the Camaros for a shake down run in case I want to do Power Tour or something. Turbo car got 14 on e85 and vert got 18 on 93 with cruise set to 90 much of...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 05-18-2024, 06:48 AM
Replies: 19
Views: 901
Posted By CamaroCracka
I run SC2s, and my turbo comes in a little late...

I run SC2s, and my turbo comes in a little late so it is easier to control on the street, but it will still blow the tires off around 5k in 1st and 2nd at WOT.
Forum: 5th Gen Camaro SS LS LT General Discussions 05-18-2024, 06:35 AM
Replies: 9
Views: 383
Posted By CamaroCracka
There is just a little roll pin that holds the...

There is just a little roll pin that holds the key on. You don't even have to get them cut. Just swap your existing key into the new fob.

FYI, in my experience the aftermarket fobs don't last as...
Forum: 5th Gen Camaro SS LS LT General Discussions 05-18-2024, 06:29 AM
Replies: 2
Views: 260
Posted By CamaroCracka
If you go with the factory AAM 3.91, there is a...

If you go with the factory AAM 3.91, there is a good chance you won't need to change any shims. I'm not sure about when you go with aftermarket gears.
Forum: 5th Gen Camaro SS LS LT General Discussions 05-17-2024, 11:11 AM
Replies: 23
Views: 1,373
Posted By CamaroCracka
It was approximately a $10 part. You could ask...

It was approximately a $10 part. You could ask him to proactively replace them once he determines what the leak is.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 05-17-2024, 07:16 AM
Replies: 13
Views: 447
Posted By CamaroCracka
I have the G8 reservoir on one and a Wilwood on...

I have the G8 reservoir on one and a Wilwood on the other. Rubber cap on both with no leaks. I think the G8 kit came with the rubber cap and I just pulled one out of parts drawer on the Wilwood.
Forum: 5th Gen Camaro SS LS LT General Discussions 05-17-2024, 06:24 AM
Replies: 11
Views: 506
Posted By CamaroCracka
I don't see any reason that would not fit with...

I don't see any reason that would not fit with the right offset, worst case a small spacer with longer studs, but you should not need spacers. I know a lot of people get squeamish about spacers, but...
Forum: 5th Gen Camaro SS LS LT General Discussions 05-17-2024, 06:20 AM
Replies: 17
Views: 603
Posted By CamaroCracka
You have the right idea. Running fuel from the...

You have the right idea. Running fuel from the bottom of the tank increases the likelihood of picking up trash or even some water if it got in there. It would also cover less of the fuel pump...
Forum: 5th Gen Camaro SS LS LT General Discussions 05-15-2024, 10:08 AM
Replies: 23
Views: 1,373
Posted By CamaroCracka
I pull the passenger fender liner to get to the...

I pull the passenger fender liner to get to the bolts and take it out the top, but I don't read the manual either. I also have turbo crap in the way so...

From what I understand the ball valves GM...
Forum: 5th Gen Camaro SS LS LT General Discussions 05-15-2024, 10:03 AM
Replies: 11
Views: 506
Posted By CamaroCracka
I run M&H slicks and when called before buying,...

I run M&H slicks and when called before buying, the guy was very chatty so maybe a call to M&H...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 05-15-2024, 09:56 AM
Replies: 13
Views: 625
Posted By CamaroCracka
The cooler is inside the diff and sealed off from...

The cooler is inside the diff and sealed off from the diff fluid. It takes "overcooled" (GMs words not mine) fluid from the radiator trans cooler and runs it through the diff cooler to drop the 300+...
Forum: 5th Gen Camaro SS LS LT General Discussions 05-15-2024, 09:42 AM
Replies: 14
Views: 761
Posted By CamaroCracka
Thanks I ran a 335 on an 18 with 56...

Thanks



I ran a 335 on an 18 with 56 offset using a 5mm spacer and it barely rubbed the liner, assuming you gain half an inch without the liner, that still only puts you at 355-360. I suppose...
Forum: 5th Gen Camaro SS LS LT General Discussions 05-14-2024, 06:33 AM
Replies: 14
Views: 761
Posted By CamaroCracka
I saw that, but I don't see how that works. Even...

I saw that, but I don't see how that works. Even removing the wheel liner would not get you past the frame rail unless you back halved the car.
Forum: 5th Gen Camaro SS LS LT General Discussions 05-13-2024, 03:04 PM
Replies: 14
Views: 761
Posted By CamaroCracka
Here you go.

Here you go.
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 05-13-2024, 03:01 PM
Replies: 13
Views: 625
Posted By CamaroCracka
ZL1s have a cooler in the diff that is fed trans...

ZL1s have a cooler in the diff that is fed trans fluid from the trans. Fluid runs from the radiator to the cooler in the diff and from the diff cooler to the drivers side of the trans. It is used to...
Forum: Suspension / Brakes / Chassis 05-12-2024, 09:09 AM
Replies: 3
Views: 234
Posted By CamaroCracka
Goodridge makes all kinds of brake lines, several...

Goodridge makes all kinds of brake lines, several specific to Gen5s. I'm sure there is probably some company out there that sells more expensive, maybe even marginally better, but if track guys run...
Forum: Camaro ZL1 Forum - ZL1 Specific Topics 05-12-2024, 08:56 AM
Replies: 13
Views: 625
Posted By CamaroCracka
It would take a lot of trans fluid leaking into...

It would take a lot of trans fluid leaking into the diff to make the gear oil redish. Your diff would have to be overfull. Pull the fill plug to see if it's overfull and compare the color of the diff...
Forum: 5th Gen Camaro SS LS LT General Discussions 05-09-2024, 09:27 AM
Replies: 14
Views: 761
Posted By CamaroCracka
That sort of scoop is better for trying to force...

That sort of scoop is better for trying to force air into the intake, but you have to figure out how to seal it up as there is already under hood pressure at speed so it would not likely do much.
...
Forum: 5th Gen Camaro SS LS LT General Discussions 05-08-2024, 06:40 AM
Replies: 1
Views: 219
Posted By CamaroCracka
Putting the bottom seat cover is not that...

Putting the bottom seat cover is not that difficult. I did it as the first upholstery project I ever tried with a pair of Amazon hog ring pliers and it looked factory when done. Pretty sure there is...
Forum: 5th Gen Camaro SS LS LT General Discussions 05-06-2024, 12:15 PM
Replies: 4
Views: 359
Posted By CamaroCracka
NPP uses a vacuum actuated valve to open a more...

NPP uses a vacuum actuated valve to open a more free flowing side of the muffler like a cutout does. I think most guys, when modifying an exhaust just use cutouts. GM did not invent the cutout valve,...
Forum: 5th Gen Camaro SS LS LT General Discussions 05-06-2024, 09:15 AM
Replies: 5
Views: 331
Posted By CamaroCracka
You can also build it with some nylon fuel line,...

You can also build it with some nylon fuel line, but it takes a good bit of patience. You can get the bends done with a heat gun or boiling water. Boiling water is the safer but more difficult...
Forum: Mechanical Maintenance: Break-in / Oil & Fluids / Servicing 05-01-2024, 07:22 PM
Replies: 13
Views: 900
Posted By CamaroCracka
Now that you mention it, I think I used masking...

Now that you mention it, I think I used masking tape before I took the hood off.
Forum: Forced Induction - V8 05-01-2024, 08:22 AM
Replies: 14
Views: 780
Posted By CamaroCracka
Meth or E85, if you are putting down 700+ at 7...

Meth or E85, if you are putting down 700+ at 7 lbs, add one and increase the boost. You will definitely make more power and should not be at risk at higher boost levels. E85 will cost more because...
Forum: Mechanical Maintenance: Break-in / Oil & Fluids / Servicing 04-29-2024, 04:43 PM
Replies: 13
Views: 900
Posted By CamaroCracka
I must be getting lucky with the hood alignment...

I must be getting lucky with the hood alignment as this is the first I heard of the hole drilling trick. Never needed more than a couple adjustments. I made my daughter help me on the vert since she...
Forum: Forced Induction - V8 04-29-2024, 04:33 PM
Replies: 14
Views: 780
Posted By CamaroCracka
Agree with Tartaglia, if meth added 100hp...

Agree with Tartaglia, if meth added 100hp everyone would run it. You also don't need multi-stage, just use a progressive controller with a solenoid. You can run as many jets as you like.

If you...
Forum: Camaro 1LE Forum 04-29-2024, 04:20 PM
Replies: 8
Views: 3,138
Posted By CamaroCracka
Looks like RockAuto still has some right side Z28...

Looks like RockAuto still has some right side Z28 axles, but I have not seen any 1LE axles for a while. Pretty sure GM discontinued them.
Forum: Forced Induction - V8 04-26-2024, 01:40 PM
Replies: 14
Views: 780
Posted By CamaroCracka
To be on the safe side, a lot of people only run...

To be on the safe side, a lot of people only run meth as insurance. In other words, they don't make the tune dependent on the additional "octane" it provides. Of course, then you leave a lot of the...
Forum: ZL1 Wheels/Tires 04-25-2024, 08:53 AM
Replies: 2
Views: 303
Posted By CamaroCracka
Same as SS 14mx1.5.

Same as SS 14mx1.5.
Forum: Camaro Issues / Problems | Warranty Discussions | TSB and Recalls 04-23-2024, 07:16 AM
Replies: 3
Views: 363
Posted By CamaroCracka
a compressor can be failing and still deliver...

a compressor can be failing and still deliver cold air. You would have to connect some gauges and see what the high and low pressures are.

I had to replace the compressor on my turbo car because...
Showing results 1 to 30 of 500
Page 1 of 17 1 234511 Last »

 
Forum Jump

All times are GMT -5. The time now is 09:02 AM.

Contact Us - Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - Archive - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.