I'm sorry to bring this thread back from the dead everyone!! But I have a question!
Can some one who has installed the footwell lighting give me a list of all supplies needed for this to work? I know I need the footwell lighting, a t-tap, and what else?
"I took the two black (negative) wires, cut them to a good length, stripped them, crimped on a spade/ring terminal, and attached it to that bolt mentioned earlier. See the fifth pic.
I attached the t-tap mating terminal to a fuse holder, connected this to the red (positive) wires, and plugged it in. I then tucked the wires in behind the console and generally spiffed up the wiring before I snapped the console side covers back into place."
And could someone please clarify this? I don't know how to crimp a wire, or what a spade/ring terminal is. I don't know what a fuse holder is either lol. And is there any instructions on how to pull back the console so you can thread the wires through like the OP said?
I'm sorry for all the questions..any help would be appreciated!
use small words please..
