|
So I contacted tech support about the Hazzard button and SWC issues. Here is the response. I also gave them the link to this thread.
The hazard button issue has been corrected. If you have an early release kit then you can contact customer service and they will send a new gasket to replace the one that is causing the issue.
As far as the SWC, they should be pre programmed. If you have the most current firmware revision flashed to the radio module there should not be any issues with SWC.
Jeremy Doran
MECP Advanced Certified
ASE6 Certified
Technical Support Advisor
AAMP of America
800-477-2267
|