Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - View Single Post

now · 09-22-2008, 05:49 PM

As featured on homepage.

Ive been reading the threads at CAMARO5 for what seems like years now.... and its cool to see the excitement level continue to grow around this amazing car. Im a new poster but a LONG time reader.

We manufacture stainless exhaust diverters for the musclecar/hotrod industry and are going to produce a piece for the new Camaro.

We are looking at 2 locations for our bolt in system. 1st being right beside the transmission before the X-pipe and the second just before the irs assembly- both with possibility of options for side exit pipes if space allows. I'm hoping to sneak a closer peek at SEMA in November with a camera and tape measure, however we may be subject to waiting for one to hit the street to finalize design.

I personally would like to extend an offer to the first camaro5 forum member/ camaro/owner (would have to be an SS for our inital product release) who could get to South Dakota. We would offer a free install and free product in exchange for the valuable information we gather for our final part numbers.

You guys and gals are all so cool in this forum its fun to finally lay down a post or 2 and be a part of it.

Thanks!

steve koenig
noweeds.net

UPDATED WITH VIDEO AND FOLLOWING INFO:

This is the installation and dyno testing of the stainless steel bolt in NOWEEDS.NET electronic exhaust diverter system for the 2010 Camaro SS LS3. After several dyno pulls we found consistent gains of 18hp and 27trq at the rear wheels while still keeping the factory cats, resonators, H-pipe, mufflers, and SOUND intact. This was filmed at the Dakota Digital Research and Development Lab in Sioux Falls, SD.

www.vimeo.com/4713276

09-22-2008, 05:49 PM	#1
now Drives: silverado ss Join Date: Aug 2008 Location: fairfax sd Posts: 112	NOWEEDS EXHAUST DIVERTERS As featured on homepage. Ive been reading the threads at CAMARO5 for what seems like years now.... and its cool to see the excitement level continue to grow around this amazing car. Im a new poster but a LONG time reader. We manufacture stainless exhaust diverters for the musclecar/hotrod industry and are going to produce a piece for the new Camaro. We are looking at 2 locations for our bolt in system. 1st being right beside the transmission before the X-pipe and the second just before the irs assembly- both with possibility of options for side exit pipes if space allows. I'm hoping to sneak a closer peek at SEMA in November with a camera and tape measure, however we may be subject to waiting for one to hit the street to finalize design. I personally would like to extend an offer to the first camaro5 forum member/ camaro/owner (would have to be an SS for our inital product release) who could get to South Dakota. We would offer a free install and free product in exchange for the valuable information we gather for our final part numbers. You guys and gals are all so cool in this forum its fun to finally lay down a post or 2 and be a part of it. Thanks! steve koenig noweeds.net UPDATED WITH VIDEO AND FOLLOWING INFO: This is the installation and dyno testing of the stainless steel bolt in NOWEEDS.NET electronic exhaust diverter system for the 2010 Camaro SS LS3. After several dyno pulls we found consistent gains of 18hp and 27trq at the rear wheels while still keeping the factory cats, resonators, H-pipe, mufflers, and SOUND intact. This was filmed at the Dakota Digital Research and Development Lab in Sioux Falls, SD. www.vimeo.com/4713276 Last edited by now; 06-23-2009 at 09:30 AM. Reason: added videos