Max A/C setting

[1camaro70]

the Max A/C setting does nothing on my car, shouldn't it up the fan speed and go to rec. mode?

[HTWLSS]

When in MAX position without the AC on, it shuts off the hot water. If the AC is on and you have it it max mode (and if the light lights up on the recirc button) it recycles the interior air, and also turns off the hot water to the heater core.

[WorldClassRS]

xTooltipElement
Service Information
2010 Chevrolet Camaro | Camaro Service Manual | Preliminary Information | Document ID: 2289567
--------------------------------------------------------------------------------

#PIC5185: AC Does Not Blow Cold - keywords air blower blue climate condition control dot duct hot HVAC inop inoperative left max poor right vent - (Jun 8, 2009)


Subject: AC Does Not Blow Cold


Models: 2010 Chevrolet Camaro




--------------------------------------------------------------------------------

The following diagnosis might be helpful if the vehicle exhibits the symptom(s) described in this PI.

Condition/Concern:
Some customers may comment that their AC does not appear to blow cold enough. This could be due to selecting the incorrect setting from the HVAC controls.

Recommendation/Instructions:
For Max AC operation, follow the instructions below.

Temperature must be set on the MAX position rather than being placed to the blue dot, There is an additional detent to the left of the blue dot labeled MAX.
The temperature dial should be set on the MAX setting for best AC performance.

HVAC air-outlets are set to vent position (the face logo only- top button on left dial).
Blower is set to medium or higher (twelve o'clock position or greater).
Be sure the Snow Flake LED is illuminated.
Please follow this diagnostic or repair process thoroughly and complete each step. If the condition exhibited is resolved without completing every step, the remaining steps do not need to be performed.

GM bulletins are intended for use by professional technicians, NOT a "do-it-yourselfer". They are written to inform these technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions, and know-how to do a job properly and safely. If a condition is described, DO NOT assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See your GM dealer for information on whether your vehicle may benefit from the information.

WE SUPPORT VOLUNTARY TECHNICIAN CERTIFICATION


© 2009 General Motors Corporation. All rights reserved.

[paulv7260]

Originally Posted by WorldClassRS

xTooltipElement
Service Information
2010 Chevrolet Camaro | Camaro Service Manual | Preliminary Information | Document ID: 2289567
--------------------------------------------------------------------------------

#PIC5185: AC Does Not Blow Cold - keywords air blower blue climate condition control dot duct hot HVAC inop inoperative left max poor right vent - (Jun 8, 2009)


Subject: AC Does Not Blow Cold


Models: 2010 Chevrolet Camaro




--------------------------------------------------------------------------------

The following diagnosis might be helpful if the vehicle exhibits the symptom(s) described in this PI.

Condition/Concern:
Some customers may comment that their AC does not appear to blow cold enough. This could be due to selecting the incorrect setting from the HVAC controls.

Recommendation/Instructions:
For Max AC operation, follow the instructions below.

Temperature must be set on the MAX position rather than being placed to the blue dot, There is an additional detent to the left of the blue dot labeled MAX.
The temperature dial should be set on the MAX setting for best AC performance.

HVAC air-outlets are set to vent position (the face logo only- top button on left dial).
Blower is set to medium or higher (twelve o'clock position or greater).
Be sure the Snow Flake LED is illuminated.
Please follow this diagnostic or repair process thoroughly and complete each step. If the condition exhibited is resolved without completing every step, the remaining steps do not need to be performed.

GM bulletins are intended for use by professional technicians, NOT a "do-it-yourselfer". They are written to inform these technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions, and know-how to do a job properly and safely. If a condition is described, DO NOT assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See your GM dealer for information on whether your vehicle may benefit from the information.

WE SUPPORT VOLUNTARY TECHNICIAN CERTIFICATION


© 2009 General Motors Corporation. All rights reserved.

Totally wild. My son and I were discussing this last night. Thanks for the info

Paul